Next cut from the other corner on the same side of the step flashing and along 45 degrees to the centerfold.
How to install roof flashing against a wall.
Add cement and flashing.
Step flashing redirects the water back onto the shingle.
Installing the roofing felt.
These kinds of houses often have a roof that butts against a wall.
The proper installation of flashing at the point where the roof meets wall is to use metal step flashing.
Metal step flashings are pieces of metal that are shaped like an l at least 5 inches wide and tall and 8 inches long as shown in figure 2.
Even if one piece of step flashing fails the flashing and shingle below it start the process over again.
Metal roof flashing can be use to seal gaps between roof walls.
Layer the cement on the area that you.
Metal roof flashing is a galvanized sheet metal bent at right angles with about eight to 12 inches on each side of the angle.
Do not fasten the flashing to the wall because it must float with the roof.
Use the metal break tool to bend the flashing lengthwise in the middle according to the angle of the roof joint.
The first step flashing or the corner flashing should rest.
Continuous flashing against a sidewall is one way to install a roof but it s not the correct way.
Next you will use asphalt or roofing cement.
It is commonly used in two story and side split houses.
For step flashing with a stucco wall you will be working in part on the roof.
Most flashing is 8 inches wide.
How to install roof flashing against a wall.
Installing step flashing to stucco walls step 1.
How to install roof flashing against a wall with a corner lay the underlaymentand the shingles fully up till the wall.
