How To Install Vinyl Siding Last Row

You must leave the bottom.

How to install vinyl siding last row.

Along the tops install j channel trim with horizontal siding and base trim with vertical siding. Finishing top row of siding under eaves. Be sure the top and bottom click into place. Measure and cut panel to fit.

Use this template. Using a piece of scrap siding as a template measure the width of the second to last row marking it with your pencil. If the result is a whole number you re in. Once it is in place test by sliding the last piece back and forth slightly.

Then notch the next piece to fit. How to install the top row of vinyl siding step 1. How do i put up a top piece of vinyl siding. If you have to cut the last row of siding you ll.

Score the vinyl siding at the mark and break off the excess top by. Push the top of the vinyl siding with the tabs into the utility trim just enough to hold the edge and push the bottom against the second to last piece of siding. To stiffen the trimmed section slide a length of utility trim. Divide the length of each wall by 8 inches the width of a piece of siding.

It protects the sheathing from rain snow and pests. Gap at all ends. Drop siding panel into j channel around top of window and install. Be sure to check both sides for proper fit.

Install siding as normal until you reach the second row from the top. But if the result is not a whole number you will need to cut the final piece of siding lengthwise in order to fill in. The siding slides behind vinyl siding trim pieces that hide the gap and the cut end. Vinyl siding installation is designed to hang loosely on the sheathing so that it can expand and contract with temperature changes.

Measure and cut panel in the same manner detailed in step 14 but cut lower portion instead of top. Below the top of the foundation but the lower the vinyl siding is installed the better. Push up gently until you hear a click. Measure the gap remaining at the top of the wall.

The bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in. To prevent the relatively thin panels from buckling observe these fitting and nailing rules. With the insulation backing in place install siding to within one row of the bottom of the window. Mark the length of vinyl where the cut needs to be made to achieve the correct fit.

Cut the trim so it is two channel widths longer than the opening s width.