This is where that box cutter comes in i think we did about 3 inches out from the bulletin board and then cut the tubes to fit.
How to make a bulletin board awning.
Use your template roof to measure and cut angled truss boards then screw them together and into the end caps.
Create a 2 dimensional square frame and attach an equally sized square frame to it so they share a middle spine.
Nov 25 2012 how to make a bulletin board awning for your classroom.
Purchase 1 inch wide by 6 inches long 2 54 cm wide by 15 24 cm long boards to create the awning frame.
Then i folded about 3 inches of the long side of each piece over.
Install drip edge flashing along all the plywood seams.
Make 2 identical 2 dimensional right triangle frames attached to the ends of your square frame.
This fold will allow your awning to either slide behind the top of your bulletin board or you can staple it to the wall.
Install face trim on both ends plywood on top and face trim on the front.
First i divided two pieces of poster board in half the long way and cut them apart.