How To Patch Roll Roofing

Set a new roll at.

How to patch roll roofing.

Use a trowel to scoop up the roofing cement. Spread the roofing cement along the edges of your roof so it s about 1 8 1 4 inch 3 2 6 4 mm thick. You can get roofing cement at the local hardware or building supplies store. Go up to the roof and locate the section of roller roofing that you will need to replace.

Cut this patch so that it is at least six inches from the hole on all sides. Remove the nails that are holding the damaged rolled roofing in place with a cat s claw nail remover. Such a patch should be flattened by laying it in the sun for a few minutes until it loses the curve from being rolled. Here are the needed steps to do it.

Press this roll roofing into the tar and make sure the edges are all flush with the roof surface. Round the edges of the patch. Tap the end of the tool with the hammer to force it up and. Ensure the nails that.

For small holes it might suffice to clean out the damaged area and fill it with roofing tar or roof sealant. If the roof deck is in good shape then it should be a fairly straightforward repair. Larger areas of damage may require you to cut out the damaged area and replace it with a new section of roll roofing. If the leak is a.

After setting the patch in place press it lightly and drive roofing nails around its perimeter. Roll roofing is typically made of the same material as asphalt shingles but it can be cut into strips. How to repair rolled roofing or how to patch a rolled roof 1. Cover the repaired area with a patch of roll roofing.

Place the tip of the tool at the edge of the nail head. Remove the nails that were used to secure the. You might have done this from the inside of the. Apply roofing cement to the roof.

If you did replace the substrate add layers of rubber roll roofing until the area is flush with the surrounding roofing. By using cat s claw nail remover lift off the nails that hold the damaged rolled roofing in its current place.