Insert the siding removal tool where the panels overlap and pull down and out.
How to remove and reattach vinyl siding.
After you remove the nails from the top of the piece of siding it is still hooked to the piece below it.
Under normal circumstances vinyl siding should not come loose if it was originally hung properly.
These hooks can be found in most home improvement or hardware stores.
First remove the corner piece then slide the zip tool under the siding and loosen it up.
The vinyl siding zip tool will save you loads of time.
Locate the loose panel.
Look for a horizontal seam between two courses of vinyl siding.
Push the siding downward to remove it from the piece below it.
Diy how to fix loose vinyl siding with a malco sideswiper siding tool.
Hold the removed segment up to a spare piece of vinyl siding.
Cut a vinyl patch 4 inches 10 cm wider than the removed segment.
Pull the panel toward you.
Place the palms of your hands on the siding and apply downward pressure until the piece pops free.
How to retack siding.
Remove the siding in the reverse of how it was installed.
If rotten wood.
Hgtv expert henry harrison shows how you can reattach it using a vinyl siding removal tool also known as a zip tool.
How to repair loose vinyl siding step 1.
Cut the spare piece of vinyl along the marks using straight tin snips.
15 minute vinyl siding repair with a zip tool.
Each panel has a.
Be careful because older siding can become brittle.
Measure and mark a point 2 inches 5 1 cm away from each side of the removed segment.
Slip the notch of the siding removal tool into the ridge at bottom of the vinyl panel.
Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip.
Vinyl siding is installed from the bottom up.
Be sure to leave about 1 8 of the nail exposed to allow the siding to flex.
Pull the piece of vinyl siding downward to disengage it from the course below it.
Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it.
After you get the siding loosened reattach the corner piece.
