Install the kickout flashing underneath the first shingle photo 1.
How to remove siding install flashing.
Then tack the ledger into place with 16d nails.
For a wood window unit drip cap flashing can be installed over the trim piece often called brick molding that comes.
The type and location of the flashings will vary depending on the type of windows and doors.
In certain instances flashing may need to be installed on the exterior of siding.
Step flashings are quite often improperly installed on the exterior of siding.
A the flashing was not properly installed.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
Using a pry bar you will need to remove a layer of siding from above the window you want to install the drip cap on.
Fold the roof side of the.
Use a zip tool to disconnect two pieces of siding.
Reveal the nails anchoring a piece to the wall by sticking the zip tool under the bottom of the piece above it.
Avoid using galvanized flashing with acq treated lumber because it can cause corrosion.
Begin by removing the shingles at the affected area and removing old flashing if present.
However in most instances step flashing should be installed behind siding.
In other words you will have to rip off the.
Install undersill trim along the edge of the vinyl over the flashing at the top and bottom.
To remove a piece at your eye level slide the zip tool under the piece above that one.
Lay a shingle over the step flashing starting at the roof edge.
Add felt if needed before nailing the new wood on and prime the new wood on all four sides before installing it.
Attach the flashing tape above the window and then slip the drip cap into the siding and attach to the tape.
If you have vinyl or metal flanged windows for instance you can install drip cap flashing 4 the home depot over the window itself or over the top trim piece that you install.
Next slide drip flashing behind the vinyl so the lip fits over the top of the ledger as shown at right.
Slice along the bend line about 4 inches into the first piece of flashing at the bottom of the roof with tin snips.
Fasten that shingle with two galvanized.
Cut the drip cap to the correct size for your window.
Nail j channel along both sides of the cutout.
Failing to install step flashing behind siding.
If the shingle already has flashing on it the kickout flashing has to slip beneath it and you ll have to loosen or remove siding to do this.
Use an old rag to remove any dirt or debris that may be there.
How to install step flashing under siding.
