How To Remove Siding Nails

To pull each nail you first need to raise the head a small amount.

How to remove siding nails.

The job was to remove the metal siding without damaging it and reuse it for another building. Take your hammer and find out the nail you want to remove. Run the blade at a 45 degree angle just before the sidings nailhead. Slide the blade of a hacksaw.

The best way to do that is to pound the pointed jaws of a cat s paw under the head. The force of the hammer is usually enough to. Keep prying until the head rises from wood or other surfaces. If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in.

Insert a pry bar between the piece of siding from which you want to remove the nails and the one above it. When the head rises make a secure and tight hold on the head of the nail and create a sideway with a little bit pressure. If the siding is hard to remove try tapping it with the palm of your hand. Unlock the course of siding above the tightly nailed piece sliding the unlocking tool along underneath the lap.

Use a mallet or hammer to gently drive the tip of the bar up behind the siding if necessary. How to remove nails from siding 1. Ive used a small angle grinder 4 inch with a metal cutting blade. Step 2 pry the piece of siding out toward you gently to let you see the nail or screw patterning of how the planks have been fastened to the under structure.

Press the upper siding board back against the wall leaving the popped nail heads accessible. If it remains stuck double check to see if. Loosen the tight nail or cut it with a hacksaw. Lift the siding up and look for nails that have been hammered in too tightly.

It was installed with ring shank nails. Pull them out with a.