How To Remove Vinyl Siding Shutters

Evaluate which type of shutter mounting system holds your shutters in place.

How to remove vinyl siding shutters.

Use a garden hose and spray the water downward to avoid getting any beneath the siding panels where it can damage the. Many shutters especially those made of vinyl are installed with fasteners called shutter locks. If you need to remove the house shutters but the screws have no head you cannot remove them like you would a traditional screw since there are no grooves for a screwdriver. How to remove vinyl shutters step 1.

Removing exterior vinyl shutters that are installed with shutter loks a small chisel with a sharpened edge a hammer silicone or caulking compound a diagonal cutter an electric drill with a 1 4 drill bit. My vinyl shutters are screwed into the siding you should be able to just unscrew them. Use care when removing shutters because this. Place a chisel bevel side up on the face of the shutter with the tip of the chisel below the rounded face or button of the pin.

How to remove and re install shutters that were installed with shur lok fasteners. Ask this old house painter mauro henrique helps a homeowner properly clean and paint her vinyl shutters. If it remains stuck double check to see if. Shutter locks are plastic screws that have a flat head and are tapped into the side of the building to attach the shutter.

Tap the chisel with a hammer to cut the end off the pin off flush. Rinse the trim with a light spray of water to remove dust dirt and debris. If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in. Plastic shutter screws are called shutter locks.

Most shutters have six pins one at each corner and one in the. Shutters that are not screwed on with screws are. Thisoldhouse asktoh subscribe to this old house. Lift the shutter off the brackets if you have newer model shutters.

How to take pins out of shutters.