How To Replace An Awning Motor

Replacing the motor on a solara power awning extend your awning about 2 feet.

How to replace an awning motor.

Loosen the awning bolts. If this is the case unplug the motor from the electrical source. How to replace rv awning fabric. Use the manual override if the motor is completely.

Remove the cap spring. We carefully unfolded located front and back and slid the new rv awning with the attached polly cord into the awning roller. We then secured the polly cord with screws to the roller. Afterward head to a home hardware store and purchase an appropriately sized replacement fabric.

Unbolt the chain from the drive shaft of the awning motor. Check the manufacturer s instructions for fabric recommendations. Refer to the owner s manual as the parts included can be slightly different from manufacture to manufacturer. Choose a fabric replacement.

The steps to replace the rv awning are almost the opposite of the removal. Tie the awning arms off to the bracket where it attaches to the side of your rv. Reinstall the gear for the manual handle. Use high quality heavyweight tight weave vinyl for the best results.

Start by measuring your awning from the inside of each cap. New motor and wind sensor. Loosen the bolts holding it in place and lift it out of the housing. Attach the hardware one by one.

This will give you room to work. Install a new motor and tighten the bolts. Client on a budget. Do this on both ends.

If you thought replacing your rv s main patio awning was out of your league as a do it yourselfer watch this first and you just might change your mind. Purchase a replacement awning fabric. To do so measure from the center of one arm to the.