How To Replace Awning Motor

Refer to the owner s manual as the parts included can be slightly different from manufacture to manufacturer.

How to replace awning motor.

Afterward head to a home hardware store and purchase an appropriately sized replacement fabric. Replacing the rv awning. Pull out the motor unplug the wire plug in the new motor and reverse everything. Reinstall the gear for the manual handle.

The steps to replace the rv awning are almost the opposite of the removal. New motor and wind sensor. You will need pop rivets reinstall the end cap. Start by measuring your awning from the inside of each cap.

Loosen the bolts holding it in place and lift it out of the housing. Use high quality heavyweight tight weave vinyl for the best results. Check the manufacturer s instructions for fabric recommendations. Purchase a replacement awning fabric.

Attach the hardware one by one. Client on a budget. Once the awning is in place make sure the lower section of the legs are locked in so you don t have to worry about it falling. Use the manual override if the motor is completely.

Don t pay a shop to to replace your powereed carefree of colorado rv patio awning fabric. Unbolt the chain from the drive shaft of the awning motor. We ll show you step by step how easy it is to do it yourself. Here we cut the remainder of the old awning fabric from the roller and pulled out the polly cord from the retaining track.

Lift the roller up so it comes loose from the arm. Drill out the rivets holding the end of the cap on the end of the roller. If this is the case unplug the motor from the electrical source. Do this on both ends.

Replacing the motor on a solara power awning extend your awning about 2 feet. Replace the awning on the rv with your helpers lift the arms of the awning against the rv walking the awning in slowly as someone feeds the fabric back into the channel. This will give you room to work. Install a new motor and tighten the bolts.