How To Replace Electric Awning Motor

Best seller in patio awnings.

How to replace electric awning motor.

Drill out the rivets holding the end of the cap on the end of the roller. If your awning is really old use a sharp edge to cut away the sealant that connects the fabric to the track. Solera awning motor wires remove the 3 bolts that hold the motor in place using a 10mm wrench or socket. Loosen the roller end bracket securing bolts and remove the bracket from the torsion bar by sliding it to the left end of the bar.

Get to the motor using a ladder and open it up. You will possibility need two ladders. The dual connector three bolt system was engineered with minimal components for fast user friendly installation saving you time and money from taking your rv or camper into the shop. Free shipping by amazon.

Pull out the motor unplug the wire plug in the new motor and reverse everything. Loosen the bolts holding it in place and lift it out of the housing. Unscrew the panel box and access the point where it makes the connection. Remove the awning from the mounting bracket and lay it safely on the ground.

Carefree r001326wht white rv travel r electric awning replacement motor. Remove the bad motor and replace it with the new one. Aecojoy 10 8 patio awning retractable sun shade awning cover outdoor patio canopy sunsetter deck awnings with manual crank handle beige. After your awning is safely on the ground remove the end cap.

Be sure to apply tape before sliding the awning off the rv. Remove the connection and test the voltage at that point. You have to connect back the wiring connection at the awing wiring and coach wiring before you do this step otherwise you wont have the voltage. This should be done in a retracted position.

Unbolt the chain from the drive shaft of the awning motor. Install a new motor and tighten the bolts. You will need pop rivets reinstall the end cap. With the solera power awning replacement motor your awning will be operating as usual in no time.

Connect the chain for the awning and plug into the electrical supply. This will make sure they don t scratch the side of the rv. Get it as soon as sat sep 19. You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes.