Then fold the excess tarp under a few rotations for a tight clean fit.
How to tarp a roof without nails.
Thomas boni july 8 2018 at 3 29 pm.
Extend the top edge of the tarp over the roof.
Next on the peak side attach the tarp to the 2 by 4 using cap nails.
These nails should be placed 12 to 18 apart.
Find the source of the leak.
Starting at a corner drive a galvanized roofing nail into the strip and into the roof sheathing.
Never lay the tarp out during a storm.
Next install furring strips to the parallel bottom side of the tarp.
Once you re on the roof and ready to rock and roll spread out your tarp to the coverage you want.
Don t simply nail into the tarp.
Continue along the length of the ridge line.
You need to know first which spot on the roof needs tarping up.
Time wind and rain will eventually pull those nails right through the tarp if you don t use wood and you ll have a flapping tarp on your roof doing nobody any good.
The board must be 2 feet longer than the tarp s width and it should sit against the roof to avoid the collection of rainwater snow or debris.
Wrap your tarp around the board then secure the board to the roof with a screw.
Nail the tarp to the fascia board over the edge of.
Installing tarp on a roof without nails.
Lay the tarp across the roof so that at least 4 feet 1 2 m lies on the sloped part of your roof on each side known as the peak.
It s even easier if you do it without nails.
Your 2 4 should be two feet longer than the width of your tarp.
Installing a tarp on your roof is easier than you think.
How can can i use a tarp on a metal roof without the the nail put a hole in my shingles.
Using nails attach the peak end of your tarp to a 2 4.
Roll the tarp over the damaged area taking care that it extends at least 3 on all sides.
You may need to put nails in or around your soffit area to tie off the ropes and tarp.
Here are the steps on how to install a tarp on your roof without nails.
Let the rest of the tarp hang off the lower border of the roof that overhangs the wall known as the eave.
Most tarps have grommets that will allow you to tie off the tarp to your roof.
Create an anchor board by rolling the tarp s peak end with a 2 x 4 inch board and nailing the tarp to your board with your 3 inch nails.
The 2 by 4 should be about 2 feet longer than the tarp width.
Lay the tarp out flat over the roof.
Place the plywood or sheet metal over the hole and use roofing nails and a hammer or decking screws and a cordless drill to secure the plywood to the roof.
Place the 2 4 against the roof along the rake to prevent water collection.
Pull the tarp tight and smooth out wrinkles.
