Howmtomlower One Side Of Sierra Rv Awning

Slide the rafters down to the rest position.

Howmtomlower one side of sierra rv awning.

Adjusting your retractable awning is not as difficult as it may seem. Flip the control lever on the right side of the roller tube as though you were preparing to fully extend the awning. If you have a standard spring loaded awning with small black rafter knobs loosen the knobs now just a few turns are necessary don t remove them or loosen them all the way. Be sure to ask for paul the air force guy when you stop by and receive free 100 coupon to our parts store w rv purchase when you mention you found me o.

You should now be at the rear of the awning facing the front. Some awnings have mechanisms that allow you to adjust them with ease. If necessary use a screwdriver or other tool to pry open the awning extrusion track on one side. Set one side of the awning lower than the other if it rains this will allow the water to run off instead of collecting on top of the awning.

Pull the awning strap to one side and tie it to an arm to keep it out of the way. Rv adhesive tape release a sticky awning ratchet lever by releasing the awning lever with one hand while pulling down gently on the awning support arm with your other hand. Once you have your awning installed you might need to make sure that the slope is the right angle and the extension is appropriate. When done pop the lower ends of both awning arms out from their brackets on the side of the rv and extend them until they are both touching the ground.

Lower the awning arms to the rest position. Rotate this leg clockwise as many times as you did the front leg. Next do the same to the other side of the awning. There is one at each end of the awning.

Pull the support arm to release the ratchet attached to the other end of the lever. Step 1 undo the travel latch or lock that holds the awning to the side of the rv. Grasp the awning to prevent it from rolling up by itself. Loosen the rafters knobs and release the rafter catches.

So reattach the front leg to the side of the rv and raise it up a bit. Lower the rear leg detach it from the rv and prop it up on the ladder like we did for the front leg in the previous steps.